Hello, I’ve been using the Time to Exhaustion app yesterday, I put the new code generated by Xert and since then it does not work, I put the watts to where to be exhausted and loading it with the new code in the Edge 1000 the application comes out with Symbol or only the total time of the output appears to me. The same code is used for the “MPA AND POWER” app and in it if it seems all correct. Any solution? If that works by putting the code that goes by default when downloading the app again. But it is not code generated by my signature
You may need to “fight” the Garmin app installation and configuration process. You can try removal and reinstallation. You may also want to try and reboot the 1000 in between. There was some discussion on this in the Xert Users group on Facebook.